Need help with Proton Pack Powercell lights

ForbiddenOnion

Active Member
Hi everyone. Looking for some advice.

Switched on my proton pack this morning and noticed for some reason the direction of the powercell lights had reversed. I'm using a jupiter electronics kit and have never had an issue and up until today the lights were scrolling bottom to top as they normally would. Has anyone else had this issue? I have no clue how this could have happened as the pack has been in storage in my closet since October. Any advice would be greatly appreciated.
 
There is a blue control switch that regulates the speed. Turned, it can also alter the direction on both the red light and blue light bar. Just adjust that switch with a turn of the screw on that board and you should be able to reverse it back.
 
This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top