need help with pep scaling


I need some help scaling a pep file, I've never done any pepwork before, and I don't want to screw it up. I am working on a dovahkiin helmet from skyrim, and I'd like to know how to scale it properly to make it fit.
For most helmets I've built I go by width. I'll measure the width of my head, convert the inches to mm and input in the width factor.
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.