Need advise about molding a helmet sculpt

Thread starter tmatelski
Start date Jun 6, 2015

tmatelski

New Member

Jun 6, 2015

I am going to be sculpting a helmet and I was wondering if anybody can give me information on how to mold it and what to run it out of. I have sculpted masks and appliances and molded them but this is my first attempt to make a plastic helmet. Thanks for any advise.

This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

Your new thread title is very short, and likely is unhelpful.
Your reply is very short and likely does not add anything to the thread.
Your reply is very long and likely does not add anything to the thread.
It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
Your message is mostly quotes or spoilers.
Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
This thread is locked.