My Slow P2 Build

Klwl

Sr Member
I thought it was time to post "something" on my build due to needing a kick in the pants to keep it going. I have a few parts now I can work on and is being worked on so without further adue:

P2 Skins by Gene (MEANGENE83): I have still to reinforce thin areas and finish removing the seam on them


P2costume016.jpg



Before zipper at back:

pred2001.jpg

pred2003.jpg



P2 closed mouth by Lee and currently being painted by "Master Lee"


st1.jpg

st2.jpg

st3.jpg

st4.jpg




So that's it for now, I will post up hopefully later this afternoon after I finish installing zipper.

Comments and suggestions welcomed...... I need that extra push to keep on track :)
 
Ok zipper is finally installed....I ran out of latex on 1st side so I had to use another bottle unfortunately it was brown and look like I shat on it. I've tested it out and works well so I will sew in the zipper and reinforce again with a layer or 2 of latex.

more to come......

IMG_9202.jpg

IMG_9204.jpg

IMG_9203.jpg
 
This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top