My DeAgostini Falcon. DONE!

Jun Austria

Well-Known Member
Started painting this beast last November 2020. And finished on 4th of May 2021. Finally, I can move on to another project and regain a large space on my workbench. My intention is to follow the studio model. So I didn't include the interior. Replaced some original parts with a 3d printed parts for the Cockpit Cone and the Headlight walls. And installed a metal framing inside the model for the support stand to grab on. Thank you for looking.
 

Attachments

  • IMG_0018.JPG
    IMG_0018.JPG
    3.1 MB · Views: 556
  • IMG_0020.JPG
    IMG_0020.JPG
    3.6 MB · Views: 477
  • IMG_0021.JPG
    IMG_0021.JPG
    3.5 MB · Views: 425
  • IMG_0023.JPG
    IMG_0023.JPG
    4 MB · Views: 418
  • IMG_0024.JPG
    IMG_0024.JPG
    4.6 MB · Views: 381
  • IMG_0025.JPG
    IMG_0025.JPG
    3.5 MB · Views: 377
  • IMG_0027.JPG
    IMG_0027.JPG
    3.9 MB · Views: 357
  • IMG_0028.JPG
    IMG_0028.JPG
    4.3 MB · Views: 365
  • IMG_0029.JPG
    IMG_0029.JPG
    4.3 MB · Views: 428
  • Falcon ILM vs Jun.jpg
    Falcon ILM vs Jun.jpg
    6.4 MB · Views: 1,340
Looking on starting my Falcon. What parts did you replace and where did you get the parts?
The most glaring parts that I replaced is the Cockpit Cone. Below are the link for the parts I replaced.

 

Your message may be considered spam for the following reasons:

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top