My Completed Mamba Bio

MotoGuy75

Well-Known Member
Hello Fellow Hunters and Huntresses,

I recently completed my version of the Mamba Bio helmet made by Skunk.I went with a Wolf style effect.I also added one of Don Jarrs laser housings and for the hoses I used braided wire shielding with solid core wire inside to give it some stiffness.As for the paint up ,I originally was gonna use all air brush paints,but ended up going with spray can acrylics and used dry brushing for the worn silver effect.Once again for the eye lens I used dark plexi-glass wrapped in wire mesh that was spray painted black then sanded off.Oh almost forgot,also added a brass tube for the hose hole on the bottom right.

Hope you guys like it,Daren

Here are a few pics

PICT0012.jpg


PICT0010-1.jpg


PICT0011.jpg
 
One of my favorite bios so fare. I love its design.
May I suggest you to give it a weathering effect with some liquid black paint to highlight its relief ?
 
This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top