My 3 foot flying sub

Discussion in 'Replica Props' started by Robotiki, Mar 8, 2012.

  1. Robotiki

    Robotiki Active Member

    Trophy Points:
    261
    A lot of the stuff in my collection was build by others, I'm going to try and do this myself. I recently acquired a fiberglass hull for the flying sub cast off one of the filming models. It is about 3 feet wide and thick fiberglass. It did not come with top or bottom hatches, or the back panel / door / engine nozzles. Some of the stuff I'm going to have CNC cut of plexi, a couple of vaccumformed items and such. I'm not sure yet how to make a couple parts, maybe I can get some ideas from folks here as I go......
     
  2. Apollo

    Apollo Legendary Member RPF PREMIUM MEMBER

    Trophy Points:
    5,035
    You should probably post in Studio scale and general modeling.
     
  3. Robotiki

    Robotiki Active Member

    Trophy Points:
    261
    OK, if the mods will delete this thread I'll start a new one there....
     

Share This Page