MR Han Solo Blaster LE

[Solo]

I was packing my MR Solo LE this weekend for a move and noticed that ons of the grips was loose. I thought maybe the screw was a little loose, but it wasn't. I loosened the screw and found that the plastic around the inside of the hole on the grip had separated for some reason.

Anyone else have this problem with theirs? Can I just buy some replacement grips to repair the problem? It's just a Denix base, anyway.

-Solo

 

[greatwazoo42]

That happened with my Denix conversion. I just used a few dabs of two ton steel epoxy and put the busted piece back together. Since it wasn't in plain site the only thing I made sure to avoid was getting any in the screw hole.

Then again if you want to just replace them with real ones go here:

http://www.ima-usa.com/product_info.php/products_id/998

Cheap too.

 

[Solo]

Good advice. Yeah, those grips are cheap...but I would rather have plain ones. Thanks for your help.

 

[greatwazoo42]

Well a little sanding, color matched wood putty and automotive clearkote krylon and you could have them plain you know.

Good luck Solo.

 

[wuher da brewer]

I've got 9 sets of Denix plastic grips. Let me know if you need a pair for the cost of shipping.

 

[Betamin]

The MR Denix grips have the larger screw hole though, don't they? Due to the brass insert to make it look like the actual Mauser? I think I may have an extra set still around of the MR grips that they sent me. I emailed them after seeing that one grip had a bump near the bottom, and contacted them to see about getting a new one. They sent me a whole set, and it had the bump too, so it must be the Denix brand original defect. Let me look around and see if I can find them......