Mr. Black aka Berserker zbrush model WIP

poopsock

New Member
Hello,

First off, I would like to say thanks to this forum for helping me get this far with all of the excellent screenshots from Predators! Big big help.
So I'm making a character model of Mr Black for my game portfolio, still very much in progress. Most shapes are blocked out, but I need to start roughing in the armor/technical pieces.
Here's where he is at the moment:

All of the armor is just crammed on and not final in any way, so yes, i know them shoulder pads look like arse... which is where you come in!

I could really use are some good shots of the back of the shoulder harness he's wearing, shoulder pads, and his boots as well. Really, any detailed images of the inorganic pieces would be a great help, as a lot of the screenshots are dark/blurry/low-res. The action figures have actually been a very good source of reference as there's more well-lit pictures of it, so if any of you happen to have one I would appreciate it so much if you could take a moment to snap a few pictures.

All I can offer in return is my gratitude, and I'll make sure to post up some print-sized renders when I finish!

Thanks in advance!
 
Last edited by a moderator:
Excellent work. Can't wait to see the finished result.

In the meantime, here are some images of Mr. Black, hopefully these can help you with your work...

MrBlack_20_9_.jpg


HTberserkpred3.jpg


HTberserkpred4.jpg


HTberserkpred11.jpg


HTberserkpred11.jpg


HTberserkpred10.jpg


HTberserkpred13.jpg


HTberserkpred15.jpg


Normal_productionstill019.jpg


HTberserkpred3.jpg
 
This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top