Mold Making and Resin Casting articles?

Flintlock

Sr Member
RPF PREMIUM MEMBER
Where can I find a good, in-depth article on mold making and resin casting loaded with basics as well as tips and tricks? I am also interested in vacuum casting. Let me know what articles you guys have found to be informative and worth-while. Thanks.
 
Let me ask this then...

What is the best stuff to get? I was looking into Synair's Por-A-Mold and Por-A-Kast II. I also hear Alumilite's stuff is pretty good, too... but I can only find it in small quantities and it seems to be a bit more expensive. What do you guys say?
 
What you use is pretty much up to
" personal preferance " kinda' thing..

Me, I have ALWAY'S used Por-A-Kast
product's. Some like Smooth On, some
don't.. Can't say I've read much on
Alumilite stuff though ?

BTW,if you DO go the Por-A-Kast route
watch which type you buy ! I ONLY use
the Mark II stuff as you have a little
more working time with it. About 2 1/2
to 3 minutes... The Mark I is VERY fast
setting stuff, about 1 1/2 minute's !!!!!
Only good for SMALL mold's !

Just so you know..
icon_smile.gif
 
This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top