Melted Vader Sculpt (Rise of Skywalker Version)

Getting excited now, great work
Time to get excited again!!!

6B823DA9-0044-4DD7-8D4C-086F5590A9A0.jpeg
 
Last edited:
Just read this whole thread. Honestly, I was always unimpressed by the melted Vader helmet in the movies. But now, I have a whole new appreciation for it. Your attention to detail and level of accuracy are amazing. I won’t look at it the same again. Absolute work of art!
 
Really getting excited for this. How are you guys planning on displaying yours? Or if anyones got the V1 or V2 helmets how are they currently displayed?

Good discussion, I would be interested in the dimensions. I plan to present it in an IKEA Detolf alongside my other helmets.
Does the Melted Vader fit in a Detolf :)?
 
...
Just picked up a digital copy of the ROS Visual Dictionary, not sure if anyones noticed before but there looks to be a chunk of mesh deep down inside the mouthpiece. Should be pretty easy to add ourselves if desired, its probably just screen door material.
... Nice Find Blando!!! Great pic!
 
Last edited:
Just picked up a digital copy of the ROS Visual Dictionary, not sure if anyones noticed before but there looks to be a chunk of mesh deep down inside the mouthpiece. Should be pretty easy to add ourselves if desired, its probably just screen door material.
... I managed to place some mesh in there for your helm(y)... and I will put it in all the rest of everyone’s helmets too.
512976BD-5084-4DC7-8453-5512D16CF794.jpeg
 
This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top