Mek'leth deminsions


Active Member
Anyone have deminsions on the Mek'leth, I've got to either laser cut one or waterjet an aluminum but I want to get the overall size right.
Google Klingon weapons,i believe it should be 19inches from end to end,or some sites suggest to measure from elbow to finget tips.I've made a few , some oversized for my wall display,it really depends how screen accurate you want it.
Klingon weapons are usally made by induvidual warriors so every one would have differences
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.