Master Replicas 2005 Vader esb shell

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

propmainiac

Sr Member
RPF PREMIUM MEMBER
Hi all
Bought a MR Esb Vader from A member here. No internals or shroud but I have a 3d printed version that I was going to use on a short heliand flash. So being a MR saber it's a little larger than a MPP. So I cut the shroud so now it fits but I'm going to have to fill the gap . Still have to smooth out the shroud. Trying to decide if the time spent is worth it. Found a seller on the 'bay auction site who says he has original MR Vader shrouds with the thumbscrew for 35$. Not a lot of money. What would you all do here?
Here's pics. Thanks for looking
 

Attachments

  • IMG_20200421_201633.jpg
    IMG_20200421_201633.jpg
    1.4 MB · Views: 38
  • IMG_20200421_200906.jpg
    IMG_20200421_200906.jpg
    1.4 MB · Views: 44
  • IMG_20200421_200852.jpg
    IMG_20200421_200852.jpg
    1.3 MB · Views: 44
  • IMG_20200421_200852.jpg
    IMG_20200421_200852.jpg
    1.3 MB · Views: 42

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

propmainiac

Sr Member
RPF PREMIUM MEMBER
Hi all still working on this master replicas FX Darth Vader saber. So I found a seller on eBay for the shroud comes with the d-ring and the thumbscrew. Should fit and I should have it later this week. I finally managed to get the end cap off someone that had hot glued it on I had to heat it up and then give it a good twist. To fill the gap or the hole I used a washer to glue behind it and then I trimmed down a lid for container of Dremel discs. Looks more like a heliand and cap now than an MPP but I'm happy with it.
 

Attachments

  • IMG_20200424_132658.jpg
    IMG_20200424_132658.jpg
    2.5 MB · Views: 21

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Top