MARTIAN saucer from Mars Attacks!

augofett

Sr Member
I am starting a research proyect to draw some Flying saucer blueprints from Mars Attacks., and then, start a 3D "Studio Scale" model .
Any help/tips are wecome.. :)
 
Originally posted by RickDTM@Apr 9 2006, 06:55 PM
I have a small scale model of the saucer and I can take pics if you think it would help....
[snapback]1223222[/snapback]​

Yes, sure, :)
Is that a garage kit?
Does it states scale?
your help is welcome..
 
Back when the movie was originally bein made in stopmotion, there actually was a studio scale animatable flying saucer made. There were lots of tests shot on it that looked very promising. The size was around 28" - 36" foot across. It was a big bugger to animate.

Barry
 
Originally posted by Barry@Apr 10 2006, 02:28 PM
Back when the movie was originally bein made in stopmotion, there actually was a studio scale animatable flying saucer made. There were lots of tests shot on it that looked very promising. The size was around 28" - 36" foot across. It was a big bugger to animate.

Barry
[snapback]1223720[/snapback]​
I had really no idea there was a real scale model. I knew there were martians, but not saucers.
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top