Limited Run Mark 48/50 Infinity War Ironman Helmet

E9DE2740-D40E-45A3-A98D-1FC1CA1D8B8D.jpeg

Print is here! We’ll be sending out pm’s to those who expressed interest.
And yes we will be modifying the piece JKKS pointed out :)
 
Last edited:
Thanks for the deposits so far.
Managed to get some work done on it this weekend. Still a couple of touch ups and I need to add a few lines. I'm hoping to start molding next weekend if all goes well.

Also, we decided to go with 3 pieces instead of the 4 it was modeled as. It will make assembly/wearing a lot easier.

mk48-50.jpg
 
This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top