Mandalorian Mudhorn Mold and Signet (free 3D file!)

Mr Mold Maker

Master Member
Hey folks! I hope this is appropriate to post here. I modeled this Mudhorn mold and Signet based off reference from Star Wars Celebration.


If links are not allowed for some reason you can find it on Thingiverse listed under “Mandalorian Mudhorn Signet and Mold” or via my Thingiverse username JackRupert.

I think it’s a nifty little prop. Happy printing and may the force be with you.

8CC1EC87-156D-4915-B6C8-27D3C6758CF2.png
CA2910A2-B9FD-4EB5-B8DB-1829E3526531.jpeg
 
Last edited:

Vaderman

Sr Member
Neat! Thanks for sharing this.
What were you able to cast in a plastic mold? It’s an interesting idea. I would think resin would stick or the heat generated would melt most 3d plastics. Plaster should be good. Epoxy putty.
I love the finish you got on that signet in your pic.
The registration holes on the mold are a nice touch as well!
 

Mr Mold Maker

Master Member
Neat! Thanks for sharing this.
What were you able to cast in a plastic mold? It’s an interesting idea. I would think resin would stick or the heat generated would melt most 3d plastics. Plaster should be good. Epoxy putty.
I love the finish you got on that signet in your pic.
The registration holes on the mold are a nice touch as well!

It is not meant to be used as a traditional mold, it is just a replica of an in-universe piece used by the Armorer. Meant to be displayed with the signet as seen at Celebration, which is also included.
 
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Top