Mandalorian Detonator S2 EP1

MandoGuy22

New Member
Hello! This is my first official post here. After doing some searching I haven't noticed anyone designing this mando detonator. I am currently working on a 3D model but sourcing the parts would be way more fun and give the prop a much more substantial feeling! Here is a link to my first post about this on reddit: We seem to have found a few parts and have many great ideas. I've crossposted to DIY guitar pedal forums as the case looks like something they might have seen. When the parts are sourced I plan to make this light up as well.
 

Attachments

  • Capture.JPG
    Capture.JPG
    58.5 KB · Views: 205
  • Capture2.JPG
    Capture2.JPG
    60.3 KB · Views: 194
  • Capture3.JPG
    Capture3.JPG
    12.8 KB · Views: 183
  • Capture4.JPG
    Capture4.JPG
    13.8 KB · Views: 153
  • Capture5.JPG
    Capture5.JPG
    14.4 KB · Views: 150
  • Capture6.JPG
    Capture6.JPG
    16.4 KB · Views: 180
If it is a pedal I would look in the direction of tube driven models, those guard rails are present on a lot of that type
 
This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top