Mandalorian Armorer's Forge 1:6 Detolf Scale


catboat

New Member
I finished my sixth scale Armorer’s Forge based on season 1, episode 3 of the Mandolarian and images from the Art of Star Wars: The Mandolarian. I wanted to create a diorama that was a closer to cannon than other prints I found that would fit a Detolf. It has over over 70 LEDs throughout. All the files were built on Fusion 360 and Adobe Illustrator. It is a combination of 3D printed files and laser cut files that made the box.
 

Attachments

  • 972A8426-Edit.jpg
    972A8426-Edit.jpg
    299.8 KB · Views: 44
  • 972A8440-2.jpg
    972A8440-2.jpg
    327.6 KB · Views: 45
  • 972A8459.jpg
    972A8459.jpg
    148.8 KB · Views: 48
  • 972A8473-Edit.jpg
    972A8473-Edit.jpg
    316.7 KB · Views: 48

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top