Making something from fiberglass and resin, how difficult is it?


CharlesHouse

Active Member
I have basically a trash can I want to use as the base for a helmet. My concerns and two issues. One, will I be able to remove the trash can after or is it a part of the helmet? I would pull it from the bottom if possible but I assume the resin will stick to it, and if I use a release, it may not form the way I want. Second, how difficult is fiberglass and resin to work with?
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top