Aquis Hydro
New Member
I'm planning on making some skull props which I hope to cast and sell. Most likely I'll do 1/6 HT scale for now and move on to bigger stuff later.
I've got FIMO clay at the moment, which goes rock-hard in a Kitchen oven. Is this suitable for sculting?
What Casting and Molding materials do you guys recommend? Cheap, but good-quality ones preferably, as I have a very tight budget.
All designs are based on sketches I do in my free-time or found on the Net. If I can get some made, you guys will be the first to get a look in.
This Basilisk Skull is an example of my concept sketches, which I'm using for this project.
As usual, all help will be greatly appreciated, thanx.
I've got FIMO clay at the moment, which goes rock-hard in a Kitchen oven. Is this suitable for sculting?
What Casting and Molding materials do you guys recommend? Cheap, but good-quality ones preferably, as I have a very tight budget.
All designs are based on sketches I do in my free-time or found on the Net. If I can get some made, you guys will be the first to get a look in.
This Basilisk Skull is an example of my concept sketches, which I'm using for this project.
As usual, all help will be greatly appreciated, thanx.
Last edited by a moderator: