Luke V2, Knob vs Graflex Clamp location??

amish

Sr Member
Hello all,

I am just about to finish my V2 and I have looked at a ton of pictures from here and some from the movie. I am trying to find out where the knob on the bottom of the saber should be located with the graflex clamp attached to the saber.

If the clamp is at 12 o'clock, should the knob be at 4 o'clock? I have seen many different configurations and I am just looking for what is the correct position.

Thanks to all that help.

Tom
 
There is no correct position for the clamp in relation to the knob.

From looking at the photos it seems as though the clamp (or rod) was knocked loose somehow and was constantly rotating.
On my V2 I made two different holes in the handle, which allows me to set the anchor rod into two different positions . Basically I can rotate the clamp and lock into the two different positions seen in the V2 photos.

Best bet is to look at the photos, and pick your favorite position.


DS
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top