DerfOnarged

New Member
I modeled and 3D printed a lightsaber based on Narsil from Lord of the Rings. The design is based on Jake Bartok’s (IG @jakebartok) artwork, and Tehran Props (IG @tethan_props_) adaptation of it, but I wanted one to use the Savi lightsaber chassis from Disney’s Galaxy’s Edge, so I designed one for myself. All the original features of the Savi lightsaber remain unchanged including interchangeable kyber crystals, sounds, and galaxy’s edge blades. Hope you enjoy it!

51622389255_dbd3409794_k.jpg


51622168119_2550a55ce4_k.jpg


51621519756_b6bcf9fc91_k.jpg
 
Last edited:

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top