Looking for wrist gauntlet reference pictures

Thread starter ksj
Start date Feb 24, 2019

ksj

Well-Known Member

Feb 24, 2019

I am trying to figure out a simple way to make a spring loaded assembly, but need some pictures to figure out about what length and size to make the housing.

This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.