Looking for simple vacuform work in nyc area

duey2k

New Member
I have a 36in prop i need more of. It is a simple 2 sided vacuuform made piece. I want to have a few copies made to retrofit buttons and a display inside and not damage the original piece. we will do all the painting cutting an work. i just need someone to vacuum-mold the 2 parts.


we are looking to make 4 to 10pcs depending on the cost.
anyone know someone in the nyc area to handle
 
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top