Reply to thread

Message: <blockquote data-quote="ssdesigner" data-source="post: 5243479" data-attributes="member: 121"><p>This is a 1911 airsoft pistol to start with, so it is a combo of steel and aluminum parts painted a matte black color. The add-on bits are 3D printed resin. The look I'm going for is in the photos below. In most spots its a VERY subtle oxidized red/brown effect. Some rust in areas that the gun would receive a lot of hands on use. Love to get some very specific feedback on how to achieve this look. My initial thought was to start with Al-clad on the resin parts and then weather the metal parts down a bit so that everything is on a similar starting point. Thoughts?</p></blockquote><p></p>

Your message may be considered spam for the following reasons:

Your new thread title is very short, and likely is unhelpful.
Your reply is very short and likely does not add anything to the thread.
Your reply is very long and likely does not add anything to the thread.
It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
Your message is mostly quotes or spoilers.
Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
This thread is locked.