Looking for a USA board member who does metalworking.

ONEYE

Sr Member
Looking for someone in the States that does Computer Numerical Control machining, laser cutting, etc. The kind of things Russ Replicas does.

Please post contact info and examples of work in this thread.

Thanks.
 
BouncingSkullBump.gif
 
Here's the main thing I've been running on my CNC for the last few months.

CIMG1616.jpg


What do you have in mind?

The handle is CNC milled, and the blade was waterjet by a company in Utah. I'll have a 3D printer in the near future, and a laser cutter for wood and plastic, no metals though.
 
Here's the main thing I've been running on my CNC for the last few months.

What do you have in mind?

My buddy Ken will contact you soon. I'm just helping him get in contact with someone for a small project. I'll PM you a little about it in a moment.
 
Thanks for fielding this for me, Rich. Upon skill and quality, basically looking for someone dependable and trustworthy... for smaller projects to bigger ones. Example of a smaller project would be plaques and stands that I need from time to time. An example of a bigger project would be something like the Terminator Endoarm base. DrewSmith007, I will be in touch to discuss further. Thx!
 
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top