League of Legends Jinx's "fishbones" prop

Cerberus Props

New Member
so i was recently commisioned to make a fishbones prop from LoL, so far ive decided to start by using a 3 inch PVC pipe to start, then im using EVA foam to add some thickness in certain areas and to give a somewhat crude shape to the head , more progress pics soon
im making the fins out eva foamto give it shape then sandwiching the foam with polystyrene sheets (.060 thickness) and to keep it all together im using apoxie sculpt, which i will later sand down to get smooth edges
moving on to the tail, a really complex piece with many edges! what i did here was use more foam and used a dremel to get the edges to meet together, then i hot glued styrene on top
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.