chewy0987
New Member
Ok guys here's a quick one for ya's .......How to wire up your LED's or Laser's so you dont have to manually switch them on and off
Install your LED's or Laser's as you normally would in your bio and run the wire's down towards the hose connection.
Here you install a 3.5 mm jack socket but dont wire it up just yet, take a length of 2 core wire long enough to run down your arm and
back again with enough free to reach back to your bio.
On one end solder a 3.5 mm jack plug and on the other a 9volt battery connector
wire everything up, connect a battery and plug the jack into the socket at this point you need to find out which is the positive and which is negative
on the socket to get your LED or Laser's to light up, when you have connected the wire's to the socket remove jack from the socket and disconnect battery.
Now comes the clever bit, get your-self a tilt switch from your local electronics store and on one side only split the wire and solder it on,
loop the wire back on itself and tape off the end run the wire back up your arm concealing the battery under your armour on the shoulder or on the backpack
tape the tilt switch to your finger then all you have to do is bend your finger or wrist to make the connection, up for on, down for off.
on
off
All this is concealed under your skin so you may have to put a small hole in the shoulder area to run the wires through.
I hope this short huntorial is helpful if you have any questions or something is not clear i'll be only too pleased to clear things up
Apologies for large pic size must remember to reduce them down...................
Install your LED's or Laser's as you normally would in your bio and run the wire's down towards the hose connection.
Here you install a 3.5 mm jack socket but dont wire it up just yet, take a length of 2 core wire long enough to run down your arm and
back again with enough free to reach back to your bio.
On one end solder a 3.5 mm jack plug and on the other a 9volt battery connector
wire everything up, connect a battery and plug the jack into the socket at this point you need to find out which is the positive and which is negative
on the socket to get your LED or Laser's to light up, when you have connected the wire's to the socket remove jack from the socket and disconnect battery.
Now comes the clever bit, get your-self a tilt switch from your local electronics store and on one side only split the wire and solder it on,
loop the wire back on itself and tape off the end run the wire back up your arm concealing the battery under your armour on the shoulder or on the backpack
tape the tilt switch to your finger then all you have to do is bend your finger or wrist to make the connection, up for on, down for off.
on
off
All this is concealed under your skin so you may have to put a small hole in the shoulder area to run the wires through.
I hope this short huntorial is helpful if you have any questions or something is not clear i'll be only too pleased to clear things up
Apologies for large pic size must remember to reduce them down...................
Last edited by a moderator: