laser help?

Thread starter Nismo300ZX
Start date Dec 6, 2009

Nismo300ZX

New Member

Dec 6, 2009

i have a laser system and a gort bio, which means i dont have the part of the bio like on the P1 for the lasers to run into...suggestions on how i can mount this sucker? any and all input would be appreciated, as always.

This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.