Just finished my Fett helmet stand.

matt black

Well-Known Member
Good evening good people of the RPF.
I just finished my display stand for my Bobamaker helmet. I wanted something a bit different so had a go at some electronics which I had never dealt with before so it was a bit of a learning experience.
I fitted the chest lights and RF lights in the front, switches in the side and orange LED,s in the back to light up the wall and hopefully give it a bit of a carbon chamber feel about it.
It was my first real try at weathering with paint and it came out o.k. It looks much better in person than in the pics.
Not exactly mind blowing stuff I know but I thought it was a cool little idea.

All the best,
Rob.
001alvl.jpg

By bsac15 at 2012-01-17
002fjf.jpg

By bsac15 at 2012-01-17
003ppq.jpg

By bsac15 at 2012-01-17

004eo.jpg

By bsac15 at 2012-01-17


006yex.jpg

By bsac15 at 2012-01-17
 
Very classy and a great use of the details on the helmet throughout the use on the stand. The added neck makes it look even better! Kudos on a great display.:thumbsup
 
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top