Jurassic World Velociraptor Blue 3D printed Bust.....

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.


yankeetrex

Active Member
Hey everyone, after taking a bit of a physical production break on some projects, Have a few ready to go in 2019. Here is the First, this was a shared project by multi-talented artist Manuel Unda and Myself. I did the body form, and then he would sculpt scales for a few hours, then I would sculpt scales for a few hours until we finally reached a comfortable point to 3d Print a bust. We do have a full model, however we are only halfway down its back, so wont be printing that for a while.....

YmPHf3L.jpg

21HGXOd.jpg

CTLHciP.jpg

15JVJ6d.jpg


I never expected to get this level of detail out of a PLA print, but i'm excited for all the possibilities!
 

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Top