Reply to thread

Message: <blockquote data-quote="Pyrotechnic" data-source="post: 5228642" data-attributes="member: 213394">Just going through the model I'd mocked up, looks like we were very similar on some of the measurements, which is encouraging! I had 20 indentation on the bottom (2 per vial) but I think my spacing is a bit far compared to your reference pic. I also had mine at 5mm diam, but 6 seems more likely (based on a 1/4" ball-end mill bit).edit:Also, on an 'ease of machining' train of thought, my money would be on there being 24, since that'd be 1 every 15°. 20 would be every 18°, but as said, they seem too far apart, and 22 would be 1 every ~16.36°, which sounds like a nightmare to index.</blockquote>

Your message may be considered spam for the following reasons:

Your new thread title is very short, and likely is unhelpful.
Your reply is very short and likely does not add anything to the thread.
Your reply is very long and likely does not add anything to the thread.
It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
Your message is mostly quotes or spoilers.
Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
This thread is locked.