Jumanji board cover

FrankBonaparta

New Member
Hello everyone! I am new here. I started to craft a jumanji board game from 1995 but i am still stuck for the cover. I ve tried everything (3d model, make it by my own,...) but i am really not satisfied!

Is anyone have an idea where i can find a mold of the cover plaque or buy one because without it, i cannot complete the board :(


Thanks a lot for yours answers!
 
Just make sure the measurements work for what you've made, or you'll end up with a cover that's too big or too small.
 
Just make sure the measurements work for what you've made, or you'll end up with a cover that's too big or too small.


It works but since i am living in Belgium, the sending fees are way too expensive unfortunately and that 's the only seller that i saw for this article (with the fees it would be aprox. 200 $)
 
This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top