Jawa Robe Pattern

I used this basic shape on mine, the one with the separate sleeves. (This is not my pic, but came from Krayt clan I think.)

d66b7a0b2d152888b6429d9ca75e7837.jpg

Pics of how it came out on my build thread at:
https://www.therpf.com/showthread.php?t=253645&page=2&p=4344038&viewfull=1#post4344038

edit:
i remember now the upper width was determined by where the shoulder sleeve seam needed to be and the width at the bottom was just the full width of my fabric. For sleeves i just left them long and trimmed them down atfer they got sewn on. Easiest is to use a long section of fabric and fold it over. The fold becomes the top with the neck opening.
 
Last edited:
This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top