Jason part four machete version

frosty

Sr Member
Well i posted the mask version i did of this, now here is the polyfoam filled version, with the machete cut and added machete, the machete is plastic but i am waiting on a more accurate metal one, i added a new piece in the cut and a closed eye piece
443d142b874a8.jpg

443d1b0a8caea.jpg

443d1b5b08dd8.jpg

443d19028c324.jpg
 
just thought i would splosh some of the red stuff around the boards., just had my evening meal, good to know its turning stomachs across the world :lol
 
Originally posted by motman241@Apr 13 2006, 04:50 AM
That's great. What did you use for the drippy, gooey, wet blood stuff?
[snapback]1225496[/snapback]​
I use five minute epoxy, and color it with a drop or two of tamiya clear yellow and red, i have only used tamiya clears but other clears could work too.
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top