Is there an Art Asylum TOS phaser tutorial?

TheSt.LouisKid

Sr Member
I got my TOS black handle phaser from a local store and need to fix it up a bit.

I can't believe they didn't put a blue LED in it. Need to get that rear heat sink off without marring it. I know the ring glued to the front of the emitter is toast and the knurled looking sleeve part is another concern.

Anyone know a tutorial showing how to take it apart so I don't have to experiment?

Thanks.
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top