Ironman Face Plate

Thread starter Starmind001
Start date Apr 14, 2018
Tags

iron man

Starmind001

New Member

Apr 14, 2018

Hi All! First time posting, so I hope I have done this right.

I wanted to show off my 3d printed version of the Mark 2 face plate. The original face plate design was from thingiverse. It has some issues but I redesigned some of the parts to make it, say more my own. I am currently redesigning it again to make it more movie accurate and make it into a kit to sale on Etsy. I wanted to get the experts opinion on what I have done so far. I will be updating this post with more as I have them ready. Currently waiting on some resin to make copies of the newer version.

Thanks and I look forward to the new input.

This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.