Inquiry Regarding Decal Removal

patrickivan

Sr Member
I applied a decal sheet to the neck of my 1:350 Enterprise, and I really don't like how it turned out. I used decal set with it, but haven't cleared it yet.

What's the best way to remove it without damaging my paintjob under it?

I was considering just letting it soak in luke warm water with a mild detergent for a while, and then just rubbing it off.

Any other thoughts?
 

COlson

Well-Known Member
Microsol will soften up a decal again. Then it can be wiped away. As long as the paint was gloss coated before decal was attached, it shouldn't harm the paint.
 

Sindariel

Active Member
Was it a 3rd party decal sheet or the original decals from Round2? The Round2 decals are resistant to any kind of decal softener.
 
This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top