Immortan Joe silicone and resin mask

Dougie Fett

Sr Member
Just recently finished an Immortan Joe mask.
Top half is Dragon Skin silicone with punched hair, lower half is slush cast resin.

Need to make some more accurate hose connectors, if anyone had any leads that would be great?

DSC_8224 low.jpg

Bloody fantastic! And Clever. I'm working on an Immortan Joe cosplay right now, myself.
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.