I have remastered the Logan's Run Flame pistol in PLA, 3D Printed filament - Again

Thread starter propmaster2000
Start date Mar 4, 2021

propmaster2000

Sr Member

Mar 4, 2021

I was looking to do another modification to the Logan's Run Movie version pistol and this is the result.
I have done a few other modifications to the design before this one as well.
Still needs some final printed parts and painting .
.

Last edited: Mar 5, 2021

This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.