Hydroforming Sheet Metal


URIK

New Member
I'm looking for a sheet metal company that can provide hydroforming services. A die has already been made and used successfully, however the company that currently has it has become flaky and non-responsive. I tried Quick Draw Hydroforming in Santa Barbara but they were no interested in a low volume run. Preferably I'd like to find a company in Nor-Cal. but anywhere in California will do. Thanks in advance.
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top