Huge Batarang needs tips

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.


hyuma

New Member
Hi alla people, I need your advice to complete this big batarang that was asked by one person. This guy wants to hold the batarang in the centre as if it were a sword, but I don't know how to apply a "grip" on the rear. Do you have any suggest? Thanks in advance!!! [emoji2] [emoji2]

material used: polyfoam, paper machè
 

Attachments

  • uploadfromtaptalk1422615343062.jpg
    uploadfromtaptalk1422615343062.jpg
    2 MB · Views: 117
  • uploadfromtaptalk1422615444002.jpg
    uploadfromtaptalk1422615444002.jpg
    2.5 MB · Views: 87

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

spydrwebz

Well-Known Member
This is a VERY rough sketch on my part but what if you were to do something like this?

bata.jpg

They would almost be like a set of brass knuckles and if you textured the inner circle a bit it would fit pretty comfortably in the palm of the hand while providing a secure grip.
 

hyuma

New Member
which material do you this is better to do a brass knuckles? This is polyfoam i'm not sure how much weight can withstand
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Top