how to put mandibles on your mask

Thread starter khan1
Start date Aug 20, 2010

khan1

New Member

Aug 20, 2010

I am planning to make a pred suit by my self and did some research already(stil in the planning fase).I have seen that when you make your mask,you dont put the mandibles on your clay sculpture(for demolding to go easier),but i have n't found a method toput them on the latex mask after you made them.Do you use superglue.I am going to try to make the mandibles move(seen some nice threads about that) , the latex is bendy and the superglue is hard ,will this be a problem?

This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.