How to build a skeleton?

Coldblackice

New Member
I'm looking to make a lifesize Iron Man, but am wondering how to go about a skeleton/frame. The mannequin route is expensive, and seems fairly constricting with whatever proportions/dimensions are for sale.

Any suggestions on how you'd go about making some kind of lifesize skeleton/frame? You don't have to give specifics, but any thoughts/ideas would be great, especially if you could list out a few steps or ideas on how you might go about it.

Thanks!
 
I'm looking to make a lifesize Iron Man, but am wondering how to go about a skeleton/frame. The mannequin route is expensive, and seems fairly constricting with whatever proportions/dimensions are for sale.

Any suggestions on how you'd go about making some kind of lifesize skeleton/frame? You don't have to give specifics, but any thoughts/ideas would be great, especially if you could list out a few steps or ideas on how you might go about it.

Thanks!
Here's a tutorial on how to make a duct tape dummy to mount your armor on. Hope this helps and best of luck with it. :D
 
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top