Ive just got hold of a hollowed out darth vader lightsaber. All electronics have been removed so i need to find some parts to finish it off for display purposes. My main problem is the emitter. I understand internally it should be a coiled spring with a nut in the center. Any ideas on how i could recreate this? i have very little skill or tools so ideally id like something that i could just buy and then glue in place. Any ideas?
Hollow master replicas lightsaber
- Thread starter tatt2guy
- Start date
brimst0ne13
Well-Known Member
gimme reference pics and i can think somethin up for ya
Lichtbringer
Master Member
This piece?
Can be ordered here:
Flash Bulb Connector - Saber Kit - The Ultimate Source for Saber Parts and Creation™
Can be ordered here:
Flash Bulb Connector - Saber Kit - The Ultimate Source for Saber Parts and Creation™
Lichtbringer
Master Member
No, both serve the same purpose, just for different saber-types - as stated on the pic the left is for a Graflex-saber (Luke), and the right is for the MPP-saber (Vader).
Heimidal
Well-Known Member
Just to clarify something...is this for a gutted MR FX Vader lightsaber?
Reason I ask is that I'm not sure the diameter of that hilt is the same as that of a MPP Flash and therefore the inserts might not work as they are designed for exact replicas of a MPP Flash (or Graflex Flash)
Reason I ask is that I'm not sure the diameter of that hilt is the same as that of a MPP Flash and therefore the inserts might not work as they are designed for exact replicas of a MPP Flash (or Graflex Flash)
Yes it is a gutted master replicas. Really not worth me ordering one of these unless I know it will fit.
Lichtbringer
Master Member
Measure the inner diameter of your tube, and you can know.
the parks guts dont fit in a MR FX saber hilt - I've tried. It took a lot of customizing and grinding out the inside of the saber tube...
Similar threads
