holes in mould

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

pred beginner

New Member
is it a plaster mold? then just mix some up and plug the holes. any pics?
yea i used ultracal 30, but now im out of it was just curious if there was anything else i could use to not have to buy more ultracal. got lil bits of latex sticking up all over (y)

2011_09_01_22_00_05.jpg
 
Last edited by a moderator:

xdmray

Well-Known Member
hmmmm, i don't really see any of the bumps. just a few on the cheek there. and they are relatively small. you could just dremmel off the excess latex with the cotton wheel.

as for the mold. you could use epoxy putty.

also, i have used some wall spackle for fine cracks before but not for holes.
but this was on a mold that was crapping out early anyway, and i knew i wasn't going to get a lot of casts out of it.
 

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Top