Helped needed - Quidditch Trunk

OzDean

Well-Known Member
I’m just finishing up my Slytherin Quidditch trunk and what I’d like to do is install two small solenoids - one under each of the bludgers that would randomly fire. They don’t need to move a lot but it would look like they want to escape. I suck at arduino stuff so I was wondering if there were any premade Halloween control boxes or other circuit boards available?
Any help would be greatly appreciated.
 
This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top