help with mask shape

Wolfff

New Member
well i just finished making my P1 mask with pepakura and i noticed that the shape is kinda off and i was wondering if anyone can help me since i'm new to this. View attachment 23734

IMG_0184.JPG


IMG_0185.JPG


IMG_0186.JPG


IMG_0187.JPG


IMG_0188.JPG
 
Last edited by a moderator:

Philby

New Member
well i just finished making my P1 mask with pepakura and i noticed that the shape is kinda off and i was wondering if anyone can help me since i'm new to this.


well,....hard to tell since the pics are sideways but i'd say ( in my opinion )
that the mouth is too big and the crown is too small,.....

depends really on what you're going for but,....
compared to the P1 it just isn't quite flared out enough,......

but just my opinion ,......nothing more

EDIT--- for some reason the side view looks pretty good,.......but from the front it looks how i described
 
Last edited by a moderator:

Cathat

New Member
It looks like someone squeezed the 3d mask model with non linear scale along one axis when it was in the 3d application before converstion to paper output. Maybe they were tyring to get it to fit on 8.5x11 paper output or make a better wall mounted art or soemthing.

*shrugs

Still - looking good. its got great symmtry and everything else on it looks fine.

Cathat
 

punky859

Active Member
hot glue a few thick wires along the inside of the helmet ........ put it on your predator mask and adjust the wires as such

if you dont have a predator mask then just mess with the wires until it looks right..........or you could add some bits to it.....make it a custom helmet

i remember i used the same model and im using it again for my current predator
 
Top