Help Needed in Color Choice for 3D Printed ESB and/or RoTJ Flash Hider

darkev2

darkev2

Well-Known Member
Almost done sanding and priming and sanding my 3D printed Plastic ESB Flash Hider and I was wondering what color paint should I use for the part. I have gun metal, flat aluminum, chrome silver, steel, and titanium silver on the bench. Is there a better choice or should I use one off my list?? Any suggestions or comments would be GREATLY Appreciated!!!

Thank You!!!
 
I'd try the flat aluminum first and see how that looks.

Sent from my VS996 using Tapatalk
 
This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

W
Seeking Advice on Color and Hair Extension Layout for Krrsantan
Replies
1
Views
228
Wookieteal
W
T
Do we know what the inside of Vader’s helmet prop looks like? (ANH/ESB/ROTJ)
2
Replies
24
Views
834
Halliwax
Halliwax
Media Man
Help with Kobold flash logo
Replies
1
Views
372
Media Man
Media Man
Anakins father
Lightsaber 3d modeling and blueprints
Replies
3
Views
532
Ridire Firean
R
bogginhead
Folmer accurate pommel cap for vintage Graflex, Inc flash?
Replies
13
Views
1,007
bogginhead
bogginhead
Back
Top