Han solo blaster hoster build

ionracer24

New Member
I decided to redo my Halloween Han solo blaster holster. I made one for some costume parties i went to this past Halloween but i just wasn't happy with it. So i'm starting over. I cut out these buckles to use for the belt out of like 10 or 12 gauge sheet metal. I'm going to fabricate and weld some small steel bar stock to latch the buckles to the belt since i dont have the tools to fab up "movie accurate" latch assemblies. Tomorrow i'm headed over to Tandy to get another belt and some sewing materials to sew up the part that holds the actual gun. The previous one i just riveted together in the interest of time.
 

Attachments

  • blaster buckles.JPG
    blaster buckles.JPG
    1.9 MB · Views: 182
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top